12v Ignition Coil Dual HT Leads 100mm 30400-306-673 30400-306-672

Description
Fitments

12v Ignition Coil Dual HT Leads 100mm 30400-306-673 30400-306-672

Note: 100mm centre to centre of mounting holes version.
You may need to modify one of the bullet connectors.

12v points system ignition coil
2 wires with male and female bullet connectors
Dual lead HT
Fits Twins and either side on Fours
100mm mounting hole centres
Replacement for FL808 -12V
Used for various Vape, Boyer Bransden, Pazon and Wassell electronic ignition kits
Primary Resistance: 5.2Ω +/- 10%
Secondary Resistance: 17.8kΩ +/- 10%

Replacement aftermarket part for Honda OEM 30500-216-405, 30500-216-000, 30500-216-003, 30500-216-004, 30500-216-005, 30400-306-673, 30400-306-672

If your coil has two wires (primary) and it's not obvious to which way these are connected, do not worry as all our coils are made to fit either way.
Each of the wires are connected to the same coil of wire inside the body of the coil just at opposite ends so it does not matter which way round you connect them.
If you've been told otherwise as plenty of 'experts' will disagree with the above then this is the way to ensure you have the two (primary) wires the correct way round.

Test by hooking up a voltmeter with the negative lead to inside the spark plug cap or HT lead so it's touching metal/carbon inner and the positive lead to a grounding/earth point such as the engine block. Set the meter to the highest voltage and crank the engine over (no need to start it) which should show an upward reading of the voltmeter needle (don't be concerned with the reading). If the needle swings down off the scale, switch round the coil primary wires.

Replacement ignition coils may give resistance readings that are different to genuine ones or from what it may state in your user manual (which are known to be incorrect at times) but this will not always mean a fault. If you need to check a coil look for readings that remain stable, normal rates could read anything between 0.6 and 5.0 ohms (The higher reading typical for classics) for the primary and 6k to 14k ohms (The lower reading typical for classics) for the secondary. Only when ohms readings vary significantly or have no reading the coil can then be classed as faulty. All the secondary resistance does is change the length of time the plug sparks for, so a higher resistance literally just makes the spark stay for longer and we are talking milliseconds.

Before You Place Your Order...

Note the image may not be exactly as item received and any slight difference will not be inferior or effect performance
Check the fitment list to ensure this item will fit your vehicle
When we refer to right or left, this is as you sit on your vehicle
To find part by SKU, enter the number without "SKU" into the search box
Products containing any fluid or hazardous materials, aerosols, batteries including large lithium jump starters cannot be shipped overseas due to courier restrictions although we can ship UK offshore and Scottish Highlands at higher shipping rates
EU customers should check with your countries customs office to determine what additional costs such as tax or Import duties will be prior to purchasing. These charges are normally collected by the delivery company or when you pick the item up, they are not included in the item price or shipping charge on this website

All parts and accessories are brand new and include VAT where applicable.
Most parts are pattern or aftermarket although some will be genuine but are not always stated as being so.
The use of motorcycle manufacturers' names is for reference purposes only. We do not imply that the products we sell are made by or with the permission of the names listed.