This engine gasket set contains most of the gaskets required for an engine rebuild. This gasket set does not include any oil seals other tha...
Steel sprocket ID including splines: 15mm. ID without splines: 17mm. Gap between each spline: 4mm. Bolt hole centres: 28mm and 30mm. Number ...
Performance Upgrade: Replaces worn, damaged parts with, in many cases, upgraded materials like high-performance interface gasket material fo...
Works Racing Parts (WRP)The WRP brand relies on two factors: a strong sponsorship program that endorses the name in the racing industry and ...
Shaft size 13mm. Replacement aftermarket part for Honda OEM 28300-120-000.
These steering head tapered bearing kits are provided by Hendler to the same specification as the All Balls kits. While the quality is compa...
Outer diameter 29mm. Inner diameter 17mm. Width 7mm.
Outer diameter 30mm. Inner diameter 19mm. Width 5mm.
Outer diameter 97mm. Thickness 1.5mm. Number of pegs 8.
Some bikes have one single pull throttle cable while others have two which are: Throttle Cable A or 1 = (Pull). Throttle Cable B or 2 = (Pus...
Fits NGK D series plugs with threaded terminals. 90 degree elbow. 10-12mm. 5 kilo ohm. Terminal stud. Water resistant, vibration resistant a...
Models including Fizzy FS1E, YB100, C50, C70, NC50, PA50 and many other models use a longer HT lead than this one at 300mm. If your original...
Brand: JT Sprockets. Position: Front. Tooth Count: 15. JT Part Number: JTF253.15. Type: Standard. Material: Steel. Fitment: Direct replaceme...
Brand: JT Sprockets. Position: Front. Tooth Count: 14. JT Part Number: JTF253.14. Type: Standard. Material: Steel. Fitment: Direct replaceme...
Outer diameter 96mm. Thickness 3.7mm. Number of pegs 17. Replacement for Vesrah VP1012.
Thread 10mm x hex 5/8" (16mm) x pitch 1.00mm. Ceramic resistor. Heat range 6. 12.7mm (1/2") reach. 0.6mm fine wire iridium centre ...
Steel sprocket. Fits Honda Z50R models with a 38mm inner diameter sprocketID at 38mmOD approx 54mmNumber of bolt holes 3Pitch 420.
Outer diameter 94mm. Thickness 1.3mm. Number of pegs 8 x 2.
Steel sprocket. Fits Honda Z50R models with a 38mm inner diameter sprocket. ID at 38mm. OD approx 54mm. Number of bolt holes 3. Pitch 420.
Thread 10mm x hex 5/8" (16mm) x pitch 1.00mm. Ceramic resistor. Heat range 6. 12.7mm (1/2") reach. Standard 2.5mm copper core cent...
Steel sprocket. Replaces JT Sprockets JTR255-35.
Steel sprocket. 29mm centre ID. Replaces JT Sprockets JTR255-37.
Brand: JT Sprockets. Position: Rear. Tooth Count: 35. JT Part Number: JTR255.35. Type: Standard. Material: Steel. Fitment: Direct replacemen...
