Brake light switch with lead. Lead length 10cm. 2 wires with male block connector. Replacement aftermarket part for Kawasaki OEM 27010-1452.
Thread 12mm x hex 18mm x pitch 1.25mm. Ceramic resistor. Heat range 9. 19mm (3/4") reach. 0.6mm fine wire iridium centre electrode. 0.7...
Brand: JT Sprockets. Position: Rear. Tooth Count: 42. JT Part Number: JTR487.42. Type: Standard. Material: Steel. Fitment: Direct replacemen...
Brand: JT Sprockets. Position: Rear. Tooth Count: 44. JT Part Number: JTR487.44. Type: Standard. Material: Steel. Fitment: Direct replacemen...
Brand: JT Sprockets. Position: Rear. Tooth Count: 46. JT Part Number: JTR487.46. Type: Standard. Material: Steel. Fitment: Direct replacemen...
Brand: JT Sprockets. Position: Rear. Tooth Count: 38. JT Part Number: JTR487.38. Type: Standard. Material: Steel. Fitment: Direct replacemen...
Thread 12mm x hex 18mm x pitch 1.25mm. Ceramic resistor. Heat range 9. 19mm (3/4") reach. Special design. 0.7-0.8mm gap.
This final drive chain is the correct length and pitch for standard factory fitted sprockets. Comes with a split link only. This may not be ...
Fit yellow or coloured side of foam facing outwards. If you're working on a vintage or classic motorcycle and the original air filter isn’...
This chain comes with a split link. This final drive chain is the correct length and pitch for standard factory fitted sprockets. The RXP ch...
Non-Sealed economical chain for heavy duty usage. Made in Japan. Specifications Plate thickness (inner): 2.30. Plate thickness (outer): 2.30...
Comes with rivet link, no split link but these can be found under split links via search. This final drive chain is the correct length and p...
Piston outer diameter 34mm. Each kit contains an inner oil seal and an outer dust seal. Enough seals for 5 pistons. Made in Japan. Fit Japan...
12 volt 4AH 60 CCA. Length: 120mm x Width: 70mm x Height: 92mm. Replaces: CB4L-B, YB4L-B, GM4-3B. Please check compatibility particularly di...
Fits NGK D series plugs with threaded terminals. 90 degree elbow. 10-12mm. Resistor type rated at 5kΩ. Terminal stud. Water resistant, vibr...
Steel sprocket. Replaces JT Sprockets JTR487-43.
Height 56mm. Width 54mm. Replacement for Hiflofiltro HF123, Champion X310. This filter does not come with an O-ring. This will suit the foll...
Steel sprocket. Replaces JT Sprockets JTR487-42.
Steel sprocket. Replaces JT Sprockets JTR487-44.
Steel sprocket. Replaces JT Sprockets JTR487-38.
Please Note: This oil filter does not come with O-rings. Replacement for Hiflofiltro HF123, Champion X310. This will suit the following mode...
