Sleeve outer diameter at cable end 30mm.
Length is the total length of each grip. Length 125mm. Fit 7/8" handlebars.
Fits 7/8" handlebars. No adjuster. Matching clutch lever assembly our SKU 014898.
Round tops. Suitable for 1" or 7/8" handlebars. Riser bolts are not supplied. Suitable riser bolts - SKU: 015186.
Outer diameter 4.1mm/6.25mm. Inner diameter 2.65mm. Length 11.25mm.
Anodised blue aluminium. Overall width: 31". Rise: from top to top of bar 2.5". Centre width: 7.5". Please do not remove the ...
Fits steel 7/8" handlebars with a 17mm inner. Designed to protect your handlebars and grips in the event of a spill. Easy installation!...
Fits 7/8" handlebars.
Length is the total length of each grip. Length 135mm. Fit 7/8" handlebars.
Length: 22" (560mm). Clock fit: screw over 11mm. Tacho drive end: push in 15mm. Inner type: square/fork.
17mm bore size. 135mm length, which is a vertical straight line from inside centre of bore to the inside centre of toe peg.
Solderless nipple OD: 9.5mm (3/8"). Top fixing bolt: Slotted hex screw. Cable hole ID: 2.5mm.
Overall width: 31". Rise: from top to top of bar 3.5". Centre width: 6". Please do not remove the protective sock from your n...
Fits all steel 7/8" handlebars. Designed to protect your handlebars and grips in the event of a spill. Easy installation! screw directl...
Throttle, carb & fuel pump cable all in one for the Yamaha PW50. Throttle cable from twist to connector outer length: 525mm. Pump cable ...
Outer diameter 3.75mm/5.9mm. Inner diameter 2.5mm. Length 7mm.
Anodised gold aluminium. Overall width: 31". Rise: from top to top of bar 2.5". Centre width: 7.5". Please do not remove the ...
Top outer length: 830mm. Top free inner length: 70mm. Top fitting: standard ferrule. Bottom 1 fitting: standard ferrule. Top nipple: standar...
Half-waffle ergonomically designed pattern. Special base rubber compound for reduced vibrations and longer wear. Three pre-moulded safety wi...
Shaft size 13mm. Length 140mm.
12mm spline size. 120mm length, which is a vertical straight line from inside centre of spline to the inside centre of toe peg.
These solderless barrel nipples sits within clutch or brake lever and holds the cable end with soldered on pear nipple in place. Takes all i...
Please Note: This speedo cable is 780mm/30.5" long so you may require a longer version as listed below: Length: 30.5" (780mm). Clo...
18mm shaft size. 160mm between shaft and toe plate centres.
