Replacement aftermarket part for Honda OEM 31600-MEL-013, 31600-MEL-003, 31600-MEL-000, 31600-MFA-D01, 31600-MFA-D00, 31600-KSV-J01, 31600-KSV-J00, 31600-MFR-671, 31600-MFE-641, 31600-MFE-640
This will suit the following models as well as those listed in fitments:
When on test, 12 Volt batteries should show an output of 13.2 Volts. When the engine is running this would increase to between 14 and 15 Volts.
Yamaha and certain Honda motorcycle's use a three-phase type system, with a permanent magnet instead of an electromagnet, to regulate the current from the alternator.
Rather than controlling the output from the alternator, the excess voltage would be dumped by means of heat transfer.
To improve the transfer of heat from the regulator/rectifier you can use a silicone heat sink compound which is placed on the back of the regulator/rectifier and on the mounting point. Both surfaces must be clean for better contact and heat transference.
Also, to improve the earth of the regulator/rectifier, a cable can be introduced on one of the mounting bolts and connected directly to the negative terminal of the battery (earth side). This would eliminate the unreliable arrangement of earth fittings that are connected to various parts of the frame or motorcycle that does not always work. This type of earth is used as standard on some Yamaha and Honda motorcycles.
All parts and accessories are brand new and include VAT where applicable.
Most parts are pattern or aftermarket although some will be genuine but are not always stated as being so.
The use of motorcycle manufacturers' names is for reference purposes only. We do not imply that the products we sell are made by or with the permission of the names listed.
