Ignition Switch Honda 35100-413-007 35100-473-007 CB250 CB400

Ignition Switch Honda 35100-413-007 35100-473-007 CB250 CB400

• Mounting hole centres: 50mm
• Wires with male terminals in block connector: 6

These will suit the following models as well as those listed in fitments:

• Honda CB400 T Hawk 1980-81
• Honda CB400 TI Hawk 1978-79
• Honda CB400 TII Hawk 1978-79
• Honda CB450 T Hawk 1982
• Honda CM400 A Hondamatic 1979-81
• Honda CM400 C Custom 1981
• Honda CM400 E 1980-81
• Honda CM450 A Hondamatic 1982-83
• Honda CM450 C Custom 1982
• Honda CM450 E 1982-83

Please Note: All wires are in a single block but where the CB250 RS & FT500 have the red and black wire as single bullet male and female connections from the switch which means they will require modification by following these instructions.

1. To remove these two wires from this block you can disconnect by simply using a tiny flat head screwdriver or similar tool to press down the lug/tab on the terminal inside the block but take good care and then you can reuse them if you want to.
2. Next cut the ends off the two wires from your switch removing the male (black wire) & female (red wire) bullet connectors then strip back the insulation just enough to crimp or solder the removed terminals back on, obviously it would be best practice to use new ones.
3. You will need to take great care and un-crimp the removed terminals from this block using the same tool and then reconnect to your two wires.
4. These will then go back into the block ensuring black to black and red to red, then just push them in until they click into place.

• 6 wires with male spade block connector
• 2 keys included

Replacement aftermarket part for the following OEM numbers:

• Honda 35100-413-007, 35100-MC0-671, 35100-473-007
• and many more TBA