Models including Fizzy FS1E, YB100, C50, C70, NC50, PA50 and many other models use a longer HT lead than this one at 300mm. If your original...
Brake light switch with lead. Lead length 20cm. 2 wires with bullet connectors. Replacement aftermarket part for Kawasaki OEM 27010-1471.
Steel sprocket. Replaces JT Sprockets JTF418-15.
Steel sprocket. Replaces JT Sprockets JTF418-14.
Non-resistor type. Thread 14mm x hex 13/16" x pitch 1.25mm. Heat range 8. Reach 19mm (3/4"). Standard 2.5mm copper core centre ele...
Brand: JT Sprockets. Position: Rear. Tooth Count: 34. JT Part Number: JTR802.34. Type: Standard. Material: Steel. Fitment: Direct replacemen...
Brand: JT Sprockets. Position: Front. Tooth Count: 15. JT Part Number: JTF418.15. Type: Standard. Material: Steel. Fitment: Direct replaceme...
Brand: JT Sprockets. Position: Front. Tooth Count: 14. JT Part Number: JTF418.14. Type: Standard. Material: Steel. Fitment: Direct replaceme...
6V 6AH. Terminals: 2 (1 positive + 1 negative). Complete with battery terminals & connections. Length: 97mm x Width: 56mm x Height: 111m...
Thread 8mm. Spanner size 13mm. Pitch 1.25mm.
Bosch Type BA20D bulb holder use our SKU: 018112.
Shaft size 13mm. Length 140mm.
Top outer length: 830mm. Top free inner length: 70mm. Top fitting: standard ferrule. Bottom 1 fitting: standard ferrule. Top nipple: standar...
Length: 34" (860mm). Clock fit: screw-over 11mm. Wheel end: screw-over 11mm. Type: square/fork. Note: For a longer speedo cable use 37&...
Outer diameter 50.50mm. 2 stroke. Note: If ordering STANDARD rings these will only fit pistons supplied by us. They will not fit the origina...
This chain comes with a split link. This final drive chain is the correct length and pitch for standard factory fitted sprockets. Super Rein...
Outer diameter 50.00mm. 2 stroke. Note: If ordering STANDARD rings these will only fit pistons supplied by us. They will not fit the origina...
Genuine NGK LB05F-R red resistor spark plug cap, designed for use with 14mm spark plugs that have an exposed threaded terminal stud. The 90Â...
Steel sprocket ID including splines: 16mm. ID without splines: 20mm. Gap between each spline: 4mm. Spline width: 4mm. Bolt hole centres: 34m...
Bore size 50.00mm. Gudgeon pin outer diameter 14mm. Crown height 26mm. Piston length 64mm. Ring peg position 40mm. 2 stroke. Without ports. ...
Replacement aftermarket part for the following OEM numbers: Kawasaki 21013-006. Suzuki 32342-12021, 32341-25890, 32341-25690, 32341-12011. T...
Brand: JT Sprockets. Position: Rear. Tooth Count: 37. JT Part Number: JTR802.37. Type: Standard. Material: Steel. Fitment: Direct replacemen...
Brand: JT Sprockets. Position: Rear. Tooth Count: 39. JT Part Number: JTR802.39. Type: Standard. Material: Steel. Fitment: Direct replacemen...
