Anodised gold aluminium. Overall width: 31". Rise: from top to top of bar 2.5". Centre width: 7.5". Please do not remove the ...
Fits steel 7/8" handlebars with a 17mm inner. Designed to protect your handlebars and grips in the event of a spill. Easy installation!...
Comes complete with gear linkage. 11mm spline size. 12mm bore size. 112mm length, which is a vertical straight line from inside centre of bo...
Length is the total length of each grip. Length 120mm. Fit 7/8" handlebars.
Overall width: 31". Rise: from top to top of bar 3.5". Centre width: 6". Please do not remove the protective sock from your n...
17mm bore size. 135mm length, which is a vertical straight line from inside centre of bore to the inside centre of toe peg.
Note: Approx Dimensions. Overall width: 27". Rise: from top to top of bar 4.5". Centre width: 5.5". Pullback: 4". Knurle...
These solderless barrel nipples sits within clutch or brake lever and holds the cable end with soldered on pear nipple in place. Takes all i...
Please Note: This speedo cable is 780mm/30.5" long so you may require a longer version as listed below: Length: 30.5" (780mm). Clo...
18mm shaft size. 160mm between shaft and toe plate centres.
12mm spline size. 120mm length, which is a vertical straight line from inside centre of spline to the inside centre of toe peg.
Inner diameter 4.75mm. Length 9.65mm.
Half-waffle ergonomically designed pattern. Special base rubber compound for reduced vibrations and longer wear. Three pre-moulded safety wi...
Anodised red aluminium. Overall width: 31". Rise: from top to top of bar 2.5". Centre width: 7.5". Please do not remove the p...
Outer diameter 3mm. Inner diameter 2mm. Length 4mm.
Nylon throttle tube.
Overall width: 28". Centre width: 8.5". Please do not remove the protective sock from your new handlebars until you are 100% certa...
Overall width: 36.5". Centre width: 13". Pullback: lay bars on flat surface and measure height from flat to the highest centre poi...
Length is the total length of each grip. Length 130mm. Fit 7/8" handlebars.
Fits 7/8" handlebars.
Outer diameter 5mm. Inner diameter 2mm. Length 6.75mm.
Length: 27.5" (700mm). Clock fit: screw over 11mm. Tacho drive end: push in 19mm. Inner type: square/square.
Overall width: 26.5". Rise: from top to top of bar 4". Centre width: 6". Please do not remove the protective sock from your n...
