Fits on the back of handlebar switch and takes 8mm thread mirrors.
This kit includes the following bearings: Top bearing type 1: ID 25mm x OD 43mm x W 11mm. Top bearing type 2: ID 27mm x OD 43mm x W 11mm. Bo...
Stem length from mirror body to bend: 150mm. From bend to end of thread: 60mm. Replacement aftermarket part for the following OEM numbers:Ka...
Works Racing Parts (WRP)The WRP brand relies on two factors: a strong sponsorship program that endorses the name in the racing industry and ...
Replacement aftermarket part for Suzuki OEM 94510-08F10. Please Note: These fairing brackets are cheap and nasty in our opinion, they may be...
Fuel cap comes with rubber seal that sits between cap and tank. Two keys. Bolt holes: 7. Replacement aftermarket part for Kawasaki OEM 51049...
60mm between hole centres.
Both mirrors have 10mm right-hand thread x standard pitch of 1.25mm. Glass outer diameter 95mm. Total outer diameter 105mm. 140mm stem lengt...
Replacement aftermarket part for Honda OEM 64301-087-710ZA.
Outer diameter 60mm. 5mm threaded stud. Stud length ~12mm.
The blue shown in image is true and may be too light for some models such as the C70 1975 to 1978. Replacement aftermarket part for Honda OE...
Left-hand (Anti-clockwise) thread internal and Right-hand (Clockwise) thread external. Thread: Standard 1.25mm Pitch. All threaded motorcycl...
2:1:1 drive ratio. 60 MPH = 2000 RPM. Trip meter. 60mm body with a 67mm bezel. Depth of 43mm from base of body to brim of bezel. Goes up to ...
Drive chain case ANF125 upper and lower sections included. Length: 550mm. Measurement between holes: 280mm. Finish: NH364M (Silver). Replace...
1-7/8" ball for 43-2007 & 43-1008 receivers. Ball size: 1-7/8". Works Racing Parts (WRP)The WRP brand relies on two factors: a str...
This kit includes the following bearings: Bearing 1: ID 26mm x OD 48.5mm x Thickness 15mm. Bearing 2: ID 30mm x OD 50mm x Thickness 14mm.
Replacement aftermarket part for Kawasaki OEM 11054-1307. Please Note: These fairing brackets are cheap and nasty in our opinion, they may b...
Pillion footrests. Extended 10mm bolt. Length of pin 60mm with 30mm of that threaded.
Outer diameter of the cap body that sits over the tank filler neck: 40mm. Includes keys.
Suitable for 7/8" handlebars. Can be used as screw-in or clamp-on mirrors. Please note that mirrors are always shipped via a courier du...
Inner diameter: 26.40mm. Outer diameter: 47.25mm. Thickness: 1.00mm & 4.75mm.
Fits on the back of handlebar switch and takes 10mm thread mirrors.
This kit includes the following bearings: Top bearing: ID 28mm x OD 43mm x W 14mm. Bottom bearing: ID 35mm x OD 64mm x W 17mm. Replacement a...
These mirrors will fit any bike with an 8mm or 10mm right hand thread (clockwise) each side, left or right. Stem length: 190mm centre to cen...
